Comments on: 3D Printed Snowglobe https://ben.akrin.com/3d-printed-snowglobe/ Sat, 02 Feb 2019 22:43:00 +0000 hourly 1 https://wordpress.org/?v=7.1 By: Sada Alismaili https://ben.akrin.com/3d-printed-snowglobe/#comment-620 Sat, 02 Feb 2019 22:43:00 +0000 http://ben.akrin.com/?p=3181#comment-620 Thank you for your reply

]]> By: ben https://ben.akrin.com/3d-printed-snowglobe/#comment-619 Sat, 02 Feb 2019 14:02:50 +0000 http://ben.akrin.com/?p=3181#comment-619 In reply to Sada Alismaili.

If you put the rubber gasket in the freezer a bit, it’ll contract making it easier to go into the glass (it’s a very tight fit). Also making it wet will lubricate it a bit to help it slide. I did not glue the rubber gasket to the glass, the fit is plenty tight.

Shapeways has new materials which allow for much finer details nowadays, I’ve been meaning to revisit this house :). Good luck with your project!

]]> By: Sada Alismaili https://ben.akrin.com/3d-printed-snowglobe/#comment-618 Fri, 01 Feb 2019 00:57:16 +0000 http://ben.akrin.com/?p=3181#comment-618 Hi ,
Nice job.
What do you mean by (Putting in in the freezer for 5 minutes and adding water to its edges will help slide it in.)?

Is it to put the rubber gasket in the freezer and fill the glass with water ?
Or this is unnecessary process?

And did you glued the (glass+rubber gasket ) with the base? Or it is just easily stick able?

]]> By: wagabu https://ben.akrin.com/3d-printed-snowglobe/#comment-617 Wed, 26 Aug 2015 00:34:02 +0000 http://ben.akrin.com/?p=3181#comment-617 This would be such a wonderful housewarming gift. I would love our home immortalized in a snow globe.

]]>